Not AWD right? Drivers side header install is a bitch with the front differential in the way.
Yeah it’s a rear wheel drive but dude it was a royal pain in the ass to install the headers. I cannot even imagine what it’s like on an all wheel drive! Definitely worth paying someone competent to do it.
Need a mechanic with skinny ass arms, long lanky fingers and the patience of Jesus.
It doesn’t look as bad as you say but I do think if the tips were angled it would look perfect IMO.
The passenger side needs to be pushed up. Then it might be even with the other. Getting the rear of the exhaust to sit just right is a pain sometimes.
When I put my 4" tips on, I initially thought they were too big. Now when I see stock tips, I think "damn those are small." Give it a while and it'll grow on you.
I’ll have to get out there again and check it. I was trying to hold it exactly where I wanted as I was tightening.
You are probably right!
I like the way they look. But my ocd wouldnt allow them to be uneven.
Loosen the clamp, get a thick piece of rubber that is the same size as the tip (I used one of the rubber pads from my lift), and tap it with a hammer.
Great idea. Had thought if giving it a good bang! lol
That’s a great stocking stuffer idea! I want one!New CHMSL flasher module compatible with the 2021 rooftop spoiler CHMSL. Velleman MK178 flasher module wasn’t working after the new spoiler was installed.
![Image]()
![Image]()
Video demonstration:
Build thread: 2016 R/T - awehlage’s build
