[Tweak]

Very important to note that Eibach makes two spring sets, one for the SRT (Not the one I used) and one for the regular V8 JGC (The ones I used). The part number to the spring set is 28108.540, however if you call them directly you can order just the rear springs for $172.00 total including shipping. The part number for JUST the rear springs is 28108.002

From OP.

 

[FSTDANGO3]

Thanks I didnt remember seeing that.
I may run these

 

[Tweak]

Thanks I didnt remember seeing that.
I may run these

Only reason i remembered it is i'm trying to find all info on ride and suspensions i can since mine is still out of wack.


KLACH94 Do you have measurements from the ground to peak of the wheel wells? Seems to be how most everyone is measuring their ride heights.

 

[KLACH94]

Only reason i remembered it is i'm trying to find all info on ride and suspensions i can since mine is still out of wack.


KLACH94 Do you have measurements from the ground to peak of the wheel wells? Seems to be how most everyone is measuring their ride heights.

I don't off hand but I can take measurements this evening when I get home. So you want me to measure from the floor to the middle of the wheel well, yes?

 

[KLACH94]

Thanks I didnt remember seeing that.
I may run these

If you call them make sure to tell them you only want rear springs. They are the rear springs out of the JGC Kit (Part #28108.540). The part number for JUST the rear spring is 28108.002.

 

[KLACH94]

Only reason i remembered it is i'm trying to find all info on ride and suspensions i can since mine is still out of wack.


KLACH94 Do you have measurements from the ground to peak of the wheel wells? Seems to be how most everyone is measuring their ride heights.

OK so I had to run a few errands so I measured it every time I parked. This was I know the ground is level and I can take an average. Highest measurement was about 34 1/2" lowest measurement was 34 1/4" (See Pics). Every measurement was within those two boundaries.

 

[KLACH94]

Im not sure why i cannot for the life of me put up a picture that is right side up. I just am incapable of it i believe. Sorry

 

[BLKMAGIC]

Just an FYI for anyone who may be interested in doing just the rears as KLACH94 did, I contacted Eibach today and found out that the price has adjusted to $95.56 Per spring plus shipping, so $191.12 plus shipping, which I didn't have her price out for me because at the point I'm just order the full kit. I know its not much more than the $172 shipped KLACH paid, but at over $200 its close enough to the full kit cost to justify buying the whole thing just in case I decide I want to go lower down the road.

 

[DrDurangoTx]

I've got some custom front control arms in the works that will address negative camber. I'll be sharing the information for everyone to review once I've done my own review.

 

[Blancolex300]

Any negative effects for those that tow? I'd love to go a bit lower with my R/T, but I need to be able to pull my sled trailer. Thanks! Drop looks great btw, wheels are dope too!