I have a solid billet one I paid $75 for brand new/custom and still haven't used it yet.

IndyDurango

 

thanks! so where did you get yours?

 

It was a custom order from a few years back and I think the guy produced a dozen or so. As I stated, they were far from cheap at $75 each, but it exactly matches the factor neck with the same tilt and everything, just in heavier billet aluminum. It had to have been machined on a CNC as there was no way was it done by hand, etc.

IndyD

 

You guys have a picture? Maybe I can make one for you.

 

Grant,

here's a couple of pics of the OEM one. if you can make me one out of billet aluminum or something similar, that would be great. just let me know and thanks so much!

Indy,

if could you post a pic of your billet one that would be great.

 

Yep, that's it. Mine looks the same, just in solid billet aluminum.

 

Ok, cool! maybe Grant can make me one?

 

Be VERY careful, they're offset slightly and it has to be an exact match. I managed to put mine on backwards since they're only slightly offset and it leaked so I had to remove it and spin it 180° (after everything was installed and sealed of course.)

I powdercoated my stock one, but you really can't see much of it once the hose is on.

 

Very true, I may just powdercoat mine!