Although these are pretty straightforward with the instructions, I thought I'd post some close up pics of the install. All you need is a 3/8 socket and a couple pairs of pliers.
Fronts:
For the fronts, you start off by fitting the cover over the caliper and then fastening the clip on top of it. For both the fronts and rears, I had to bend the clips open a bit, as I couldn't get them to slide in far enough. Here is a pic of the top clip
![]()
And bottom clip:
![]()
Finished product- it took a little while to the fit just right, but once I did, it was pretty solid.
![]()
Rears:
For the rears, you start with the clips 1st, and then you put the covers over. Again, I had to open the clips up again to get a proper fit.
Top clip:
![]()
Bottom clip:
![]()
Finished product:
![]()
All in all, took me about 45 min - hr to get all 4 done. I would imagine that the process is similar, if not identical, for non- R/Ts. Hope this helps anyone who might be thinking of doing this. And yes, I forgot to take pics with the wheels on.
Fronts:
For the fronts, you start off by fitting the cover over the caliper and then fastening the clip on top of it. For both the fronts and rears, I had to bend the clips open a bit, as I couldn't get them to slide in far enough. Here is a pic of the top clip
And bottom clip:
Finished product- it took a little while to the fit just right, but once I did, it was pretty solid.
Rears:
For the rears, you start with the clips 1st, and then you put the covers over. Again, I had to open the clips up again to get a proper fit.
Top clip:
Bottom clip:
Finished product:
All in all, took me about 45 min - hr to get all 4 done. I would imagine that the process is similar, if not identical, for non- R/Ts. Hope this helps anyone who might be thinking of doing this. And yes, I forgot to take pics with the wheels on.
