Dodge Durango Forum banner

2001 durango 5.9 will not go into 4x4 please help

5.3K views 6 replies 4 participants last post by  TheOldStyle  
#1 ·
Just picked this durango up for a mud truck and can not get it to shift into 4x4.
the switch does not light up that it is in 2x4 or 4x4 hi or 4x4 low.
checked all fueses and they are good.

is it the switch? if so is there a way to hot wire it to stay in 4x4 or just have to buy a new switch?
 
#2 ·
Things to eyeball:

TCCM (under the dash by the steering column)
JB fuse 11
PDC fuse A
 

Attachments

#5 ·
Coop:
Some folks experienced an issue where the T case would switch to 4 Low on its own while driving. If this is the case, the previous owner may have disconnected the T case shift motor harness connector to remove power from it. The T case motors are somewhat rare and pricey as the demand has dropped over time. The issue could also be a bad TCCM (Transfer Case Control Module).
Don
 
#6 ·
Im having the same troubles on a recent 01 SLT 5.9 purchase... NO lights on the switch... Service 4WD light was on until I reset the computer and it hasn't returned. I haven't done much testing yet but the first thing I will do when in finally stops raining is check the fuses... then unplug the harness at the tcase and check for voltage.