Search Results for ‘transmission issues’

Hi, So I have a 2004 dodge durango with a 4.7 liter V8 in it. When I put it in drive, 1st or 2nd gear, and reverse, I have to give it 5000 rpms to start moving. I checked the codes and I have codes p0876 and p0700. I replaced the transmission fluid pressure sensor. The fluid is going past hot...

So far the vehicle has run smoothly up until this morning. Driving at slow speeds in traffic (25-35mph) as soon as I lifted off the gas it felt like the vehicle was slightly braking or towing something. Idling also felt rougher. Later tonight when it started to get worse at slow speeds I turned...

I have a 2005 Dodge Durango that has started to have a transmission problem. It began just after I replaced the water pump. When the engine is cold, the Durango will struggle to get out of first. Once its out of first it seems to operate normally. But now I have noticed that when I put the...

Yesterday, I was trying to leave to go the hardware store to get more paint when my Durango quit on me. I puled out of my driveway just fine but when I put it in drive and pressed on the gas there was a loud clunk and then the engine just kept revving. Well, my heart dropped of my chest and I...

I have an 05 Durango. 5.7 Hemi. The engine is going to aprox 3400rpm before switching out of 1st and 2nd gear. It just started about a week ago. No prior signs or slippings. Any idea? Thank you for any help.

I have 2001 dodge durango 4.7 that is occasionally going into limp mode. This happens approximately once a month, and under various conditions, there is no constant condition that is causing it. I was pulling codes p0700 and the code for the input speed sensor "I don't remember the exact code...

i have a 99 durango slt 4x4 318 it has been giving me problems lately not wanting to shift to 3rd gear acts as if it jump's into neutral then grab's. it doesn'tslip or anything else just the weird shift fluid is clean and red still any suggestion's had it looked at the trans shop say's it need's...

HI! I am Christian. I am currently in the process of taking apart my 46re transmission that was in my dodge 1999 Durango. I took some photographs of the individual parts that were in the bellhousing and wanted to know is all of them look decent, or if some of them need to be replaced. Here is...