White wire with blue stripe

Those two wires go to the Auxiliary Cooling Pump for the rear HVAC. See description below.

PUMP-AUXILIARY COOLANT
DESCRIPTION
An auxiliary electric coolant pump is used on all models
to aid in circulating the engine coolant through the
front and rear heater core (depending on application).
The electric coolant pump is mounted to the right front
frame rail by a rubber isolator (1) and consists of a
molded plastic housing (2) with two heater hose connections
(3), a 12 volt direct current (DC) motor and
impeller assembly (4) with an integral wire connector
receptacle (5).
OPERATION
The A/C-heater control operates the electric coolant pump when all of the following conditions have been met.
² Vehicle speed below 48 km/h (30 mph)
² Coolant temperature between 10° C (50° F) and 110° C (230° F)
² Front blower motor turned On
² Rear temperature heat setting above the halfway setting (60% heat)
² No fault conditions detected
The A/C-heater control turns the electric coolant pump Off when any of the following conditions occur.
² Vehicle speed above 48 km/h (30 mph)
² Coolant temperature above 110° C (230° F)
² Front blower motor turned Off
The electric coolant pump cannot be adjusted or repaired and, if faulty or damaged, it must be replaced.
The electric coolant pump is diagnosed using a scan tool. Refer to 24 - HVAC Electrical Diagnostics for more
information.

Here's the service info for the pump.

Just found the same two wires to nowhere on my 07. Not having rear HVAC I guess this is a common discovery. Coincidentally, it's in the same loom as the front right wheel speed sensor so at first I thought I'd found a possible issue related to my traction/abs lights.

What did you figure out? Did those wires have anything to do with abs/traction