Dodge Durango Forum banner
Cancel
Create thread New Garage Forums

Front seat removal

1 reading
Jump to Latest
1 - 6 of 6 Posts
#2 ·
23 - Body / Seats / SEAT, Front / Removal
REMOVAL

Here's from the manual...
Image
Image
Image

  1. Before proceeding with the following repair procedure, review all warnings and cautions. (Refer to 23 - Body/Seats - Warning)
  2. Adjust the front seat to its most forward position for easiest access to the front seat belt lower anchor cover (2) and the B-pillar trim.
  3. Grasp the upper edge of the lower anchor cover and pull it carefully upward and outward to unsnap it from the front seat cushion outboard side shield (4).
  4. Remove the screw (1) that secures the seat belt lower anchor (3) to the outboard side of the front seat cushion frame.

  5. Move the seat back to gain access to the bolts (2).
  6. Remove trim covers (1) and remove the two front bolts (2).

  7. Open the trim covers (2) and remove the two rear bolts (1).
  8. Disconnect and isolate battery negative cable.
  9. Disconnect the electrical connectors, if equipped, and remove the seat from the vehicle.
    Image
    Image
    Image
 
1 - 6 of 6 Posts
About this Discussion
5 Replies
6 Participants
Last post:
arteagamacely
Dodge Durango Forum
posts
509K
members
60K
Since
2004
Welcome to the best Dodge Durango Forum around, where you can find a great Dodge Durango Wiki and discuss the reliability of the different trim levels including the GT and SRT!
Full Forum Listing
Explore Our Forums
Durango Discussions 2014+ Durango Discussions 1998-03 Durango Discussions Dodge Durango 2018+ SRT and Hellcat Durango Purchasing