Sorry, I'm sure this has been beat to death but I cannot seem to find any posts in the search. What is the deal with these hoods not lining up? Is there just no fix for this as the rest of the lines are perfect?
![113435]( "113435")
Sport hoods do not line up with fender.
Ritty4x4
21 - 36 of 36 Posts
Better touch up that rock chip.
I think our 18 citadel is off a little. It’s not terrible. In looking at Durangos while shopping over the years I have seen this on several of them. As the pics show some are right on, some are off a little, and some are off a lot. Our lift gate is slightly off. Gap on passenger side is wider than gap on drivers side(gap to the rear quarter panel). I think it’s just mediocre build quality. Quality control not making sure the body gaps are perfect.
I saw that this morning when I took the pictures, but it's a lease ending in March and the replacement DD RT TNG is already on order.
I saw that this morning when I took the pictures, but it's a lease ending in March and the replacement DD RT TNG is already on order.
Gotcha.
I tried, but the bumper is as high as it will go.
Joined
·
561 Posts
Agree.
Joined
·
857 Posts
I agree, if you go look at Jeep GC's, they 'line up' the same way. My hood was WAY skewed on delivery, the pass side hood lip was almost touching the fender (I could barely get a piece of paper between them). The dealer did a lot of fiddling with the fenders & hood and got it a lot better, but it's not flush across the front & the Drivers side hangs a tad lower. It does follow the conture of the headlight, but looks odd. If you push it back too far, then the rear part of the hood no longer lines up with the fender by the A pillar.
Joined
·
671 Posts
don't need to go outside, looking at the pics of mine and my son's 21, both are off slightly only on the driver side... thanks again now I can't stop looking at this lol
and they both seem to be off about by the same amount and only on one side. weird. but honestly, until you all made me read this thread I had never noticed
![113459]( "113459")
![113460]( "113460")
and they both seem to be off about by the same amount and only on one side. weird. but honestly, until you all made me read this thread I had never noticed
Joined
·
2 Posts
Did you try adjusting the head light base if they are aftermarket I had to adjust mine to sit flush with the frame and the hood and I have the 03 Durango.
Joined
·
5 Posts
Dodge’s fit and finish is subpar. My Durango looks the same.
That is weird...but more noticeable on the white.
Might try adjusting the bump stop up on the driver side and lower the passenger side a bit..if necessary
21 - 36 of 36 Posts
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
