Dodge Durango Forum banner
41 - 60 of 66 Posts
Hey so I'm probably returning the morimoto kit as I do not want to use a component that may or may not blow up on me. Can you send me the link of the exact kit you bought. Also do u actually have to plug in the fuse holder that is connected to the relAy? And is there an install diagram you used to install this?


Sent from my iPhone using Tapatalk
http://www.opt-7.com/boltzen-ac-canbus-series-35w-hid-kit/


Sent from my iPhone using Tapatalk
 
Discussion starter · #43 ·
Those wires are extension wires. You usually won't use them, however I needed one to extend the wire to the driver side. Those extra hole on the rubber grommet are for halos if you choose to do that later on.


Sent from my iPhone using Tapatalk
 
Shit your right I'm sorry. I was thinking about my charger lol. So, you will need to run the factory wire through the grommet. Plug the factory wire into the extension wire, then Using a very small eyeglasses flat head screw driver from the bottom of the ballast side slip the screwdriver in and slowly pull the wires out. Feed those through the rubber grommet and then connect the wires back into the clip you will here a click when there secure. Just make sure you don't switch up the wires.


Sent from my iPhone using Tapatalk
 
Discussion starter · #49 ·
U can Text me 9175157019 if you'd like


Sent from my iPhone using Tapatalk
I ended up using my old morimoto kit after all except I didn't use resistors as like you said they can be unsafe. I am using only one capacitor and the hd relay. I'm as happy as can be and the 55w ballasts make the 5000k bright as can be lol thanks for the help


Sent from my iPhone using Tapatalk
 
I ended up using my old morimoto kit after all except I didn't use resistors as like you said they can be unsafe. I am using only one capacitor and the hd relay. I'm as happy as can be and the 55w ballasts make the 5000k bright as can be lol thanks for the help


Sent from my iPhone using Tapatalk
No problem man


Sent from my iPhone using Tapatalk
 
Discussion starter · #52 ·
Here's a before (left) and after (right) opt-7 canbus kit
Image



Sent from my iPhone using Tapatalk
Those are sick man! Mine are a little different but that's only because I'm using the 55w ballast instead of a 35w. To get that blue tint I would need to use 6500k or more bulbs. However, my ballasts r kinda loud like u can hear them when the lights are on and the car is off. Not enough to make me worry but something I thought was odd


Sent from my iPhone using Tapatalk
 
Discussion starter · #59 ·
So now I have a new issue. I installed another morimoto kit for my fog lights and when I turn the car on, only one side turns on. Everything is wired correctly. I don't understand. I even got the side they wouldn't to turn on to light up by turning the fog light switch on and off but this is annoying. Has anyone else run into this issue when installing fog light hid kits ?


Sent from my iPhone using Tapatalk
 
Hey, so I apologize for bringing up such an old thread but I’ve been looking everywhere without much luck. I have a 2015 limited with halogens and bought the 2015+ morimoto elite kit. I’m just curious where people are mounting the resistors for the lights. I looked and can’t find a good spot and can’t find any answers online. Also I saw in this thread some people mentioned not using the resistors. Can I install this kit with out them? Sorry for all the questions on such an old thread but hopefully someone can help me.
 
41 - 60 of 66 Posts